Tips & Tricks

Filter by:
Advancing durability testing methods

SimRod experience: From Belgian blocks to vehicle durability testing (part 3)

March 25, 2021

Learn how to check if you followed the pre-defined durability testing methods and procedures correctly during the actual measurements.

By Gert Frans
8 MIN READ

Simcenter FLOEFD: CFD for Design-Engineers – Part 4

January 6, 2021

This is Part 4 of a 4-part series explaining the technology behind Simcenter FLOEFD. Here I will aim to demonstrate…

By Karl Du Plessis
7 MIN READ
Simcenter FLOEFD for the engineer - Nuclear reactor

Simcenter FLOEFD: CFD for Design-Engineers – Part 3

January 6, 2021

Engineers today need practical CFD to solve increasingly complex heat transfer problems to meet strict performance and regulatory demands

By Karl Du Plessis
5 MIN READ
Simcenter FLOEFD Designer Stack optimisation Example

Simcenter FLOEFD: CFD for Design-Engineers – Part 2

January 6, 2021

This is Part 2 of a 4-part series explaining the technology behind Simcenter FLOEFD. Here we will discuss how these…

By Karl Du Plessis
6 MIN READ
Simcenter FLOEFD - CFD for Designers and Engineers

Simcenter FLOEFD: CFD for Design-Engineers – Part 1

January 6, 2021

This is a 4-part series explaining why and how Simcenter FLOEFD is the right CFD software for design-engineers. Part 1…

By Karl Du Plessis
7 MIN READ
The future of thermal design: Simcenter Flotherm BCI-ROM reduced order models in VHDL-AMS format enable accurate electrothermal circuit simulation modeling in the electronics thermal design supply chain

The future of thermal design – earlier electrothermal analysis

December 17, 2020

Learn about the future of thermal design using electrothermal circuit simulation accuracy enhanced using BCI-ROM reduced order thermal models generated from 3D thermal analysis in Simcenter Flotherm.

By Byron Blackmore
8 MIN READ
Simcenter Flotherm 2020.2 software release - faster joule heating, electrothermal modeling and more

Simcenter Flotherm 2020.2: What’s new

December 17, 2020

This blog reviews enhancements in Simcenter Flotherm 2020.2 electronics cooling simulation software release. The release is focused on extended support…

By John Parry
4 MIN READ

The easiest way to reuse models between Siemens NX and Simcenter Flomaster

December 8, 2020

One of the biggest challenges we face when working with multiple software packages is reusing models. Find out how using Siemens NX and Simcenter Flomaster.

By Richard-Merrett
2 MIN READ
Simcenter Motorsolve Motor Design Software

Using Drive Cycles in Motor Design Software

November 30, 2020

Using drive cycles with your motor design software and high performance computing (HPC) lead to better designs and a shorter V-cycle.

By trahman
6 MIN READ