Rigid-flex DFM I am not sure if you have seen a rigid-flex circuit before, but I bet you must have…
Lack of signal integrity (SI) validation is one of the key reasons board designs fail in the field. That’s why…
This supply chain intelligence blog was written by Chad Jackson, Chief Analyst & CEO at Lifecycle Insights, and comments have…
How often do you think about cybersecurity when designing a printed circuit board? Probably not very often, but with security…
This blog was written by Chad Jackson, Chief Analyst & CEO at Lifecycle Insights, and comments have been provided throughout…
An integral part of a PCB design engineer’s job is part selection. A lot of research and consideration goes into…
Apart from the typical challenges of PCB design, flex and rigid-flex PCB designers encounter a whole set of unique obstacles….
The PCB design process can be different depending on your company, but the fundamental aspects are all the same –…
