Products

Electronic Systems Design

Does trace width matter much?

I guess that all depends on what you are talking about… for Signal Integrity, trace width is very important, as...

By Patrick Carrier

Solid Edge Easter Egg and Stuff Under the Hood

This year Sunday, 20-April was Easter Sunday and I was relaxing after helping out my 11-year old with school assignment which involved creating a decorative chart on the topic of 'Easter Sunday' depi...

By Tushar Suradkar

A 'Visionary' Position for Polarion in Gartner's Magic Quadrant for Application Development Life Cycle Management

I was very pleased to find that Polarion Software has once again been designated as a "Visionary" in Gartner's Magic Quadrant for Application Development Life Cycle Management for its appli...

Getting Ready for Solid Edge University

Solid Edge University is just over a week away, and there's still time if you want to sign up. But for those of you who are sure you're going, you need to go through the agenda and decide which sessi...

NX Manufacturing

Nest flat patterns of NX sheet metal assemblies with Sigma Nest

NX and Solid Edge include very powerful sheet metal design capabilities and figure as an important part of the engineering solution for sheet metal fabricators. Nesting and fabrication applications a...

Electronic Systems Design

How the Free Land Pattern Creator in PADS will save you time! : Part 1

In this 5-part blog series I’ll focus on cool features and tips and tricks that will enable you to get...

By John McMillan

NX Quick Tips: Fill Surface

This post has moved to the NX Design Knowledge Base. The complete NX Quick Tips video series can be found here. Jerry

By JerrySarfati

Active Workspace 2.1: Improved Performance and Usability

Active Workspace increases your productivity by providing access to PLM when and where you need it, allowing you to find what you need faster

By Robert_Hidajat

Shop Floor Work Instructions Made Easier

How do you create the work instructions for your shop floor workers? How do you reconcile them with the manufacturing structure? How do you communicate changes?

By Margaret Furleigh