Digital Engineering Magazine featuring NX software

The September issue of Digital Engineering discusses Electronics Design. Featured in two separate articles are next generation solutions offered in our very own NX CAD software.

Robert Haubrock (Senior Vice President of Product Engineering Software) discusses reverse engineering and bridging the gap between Mechanical and Electronic Design.

Excerpts are seen below:

On bridging the gap between Mechanical and Electronic Design
Click here to view the article

“This makes them more MCAD-aware, but definitely doesn’t replace ECAD tools.” “Similarly, some MCAD tools have looked to build in PCB design functionality by combining ECAD and MCAD tools into a single embedded system, but that is only useful for the simplest of designs.”

– Robert Haubrock,
Senior Vice President of Product Engineering Software
Siemens Digital Industries Software

On Reverse Engineering solutions and technologies such as 3D Scanning.
Click here to view the article

“No matter how careful the scan is undertaken, there will always be noise—small fluctuations in data that will appear in the model that need cleaning up. “The important factor here is making it easy to identify and fix these small blemishes in the data. This means being able to quickly map cylinders, planes and edges into a model to make it easier to get a clean model.”

– Robert Haubrock,
Senior Vice President of Product Engineering Software
Siemens Digital Industries Software

Leave a Reply