Products

Webinar: NX CAM Simulation

Recorded Webinar: NX CAM Simulation

This webinar was delivered by Thomas Feind, Software Engineer, NX CAM Infrastructure – Customer Success, in September 2019. If you have questions about the webinar, please contact him at Thomas.Feind@siemens.com.

Follow this link to the webinar recording, “NX CAM Simulation”

Webinar: NX CAM Simulation | NX Manufacturing https://videos.mentor-cdn.com/mgc/videos/2500/63e4aaca-202b-4b8e-aa75-b6a3e6fdd5ca-en-US-video.mp4

Webinar agenda:

   00:00  –  05:45  Introduction & Warm-up

   05:45  –  32:12  Simulation Task Environment in NX CAM

   05:45  –  07:30  Using Palettes to start CAM Setups

   07:30  –  09:20  Simulation Options

   09:20  –  10:10  Simulation Time

   10:10  –  11:40  VCR Buttons & Simulation Speed

   11:40  –  13:10  Collision and Checking Options

   13:10  –  24:48  Simulation Views (Execution View, Program Manager)

   24:48  –  26:49  Machine Status

   26:49  –  27:25  Machine Components

   27:25  –  28:00  Simulation Settings

   28:00  –  32:12  Workflow External Program Simulation

32:12 – 51:48 FAQ Cycle800 in ISV/CSE

   51:48  –  01:00:00   Calling Subprogram with G command (G84)

01:00:00   –  00:01:06   Explaining dependency between to_ini file and Sinumerik cycles

NX CAM Simulation
Stephanie Aldrete

Comments

2 thoughts about “Webinar: NX CAM Simulation

Leave a Reply

This article first appeared on the Siemens Digital Industries Software blog at https://blogs.sw.siemens.com/nx-manufacturing/webinar-nx-cam-simulation/